"Larry- Clymer manual says that fuel level for left carb on your bike is
1mm, right carb is 2mm, measured from bowl parting line. From looking at
the diagram I'm guessing that they mean above the top of the bowl ..."
This is correct - above the line. The bowl is screwed to the bottom of the
carb with 4 screws and accounts for about the lower 1.5" of carburetor.
There is a distinct step in the casting where this piece attaches - that is
your measuring point. Note that the carbs don't sit level but the fuel
does, so it is important that you measure this in the center of the carb,
front-to-back, right next to the throttle stop screw.
Jeremy
___________________________________________________________________________
(un)subscribe info, archive: http://archives.itg.uiuc.edu/virago/
